24

2023

-

04

What faults may occur in the coaxial stripping machine in daily production? What is the reason?

Classification :

Company News

Industry News


What failures can occur in the daily production of the coaxial cable stripping machine? The reason?

The coaxial cable stripping machine transports the cable according to the three-phase five-wire wheel and the group outlet wheel, and carries out the breaking and stripping effect according to the total range of the tool table. So what are the causes of coaxial cable stripping machine product failure? Let's take a look at it together:

First, the thread does not peel off

1. Check the laser cutting depth of the line, and adjust the cable diameter value to reduce it.
2. The gap of the three-phase five-wire conveyor wheel is too large, adjust the gap of the three-phase five-wire conveyor wheel.
3. The peeling setting is not more than 3mm.
4. There is dirt in the threading pipe.
5. The feed setting is large and needs to be reduced.

Second, the end of the line does not peel off

1. Check the laser cutting depth of the line, and adjust the cable diameter value to reduce it.
2. The gap of the group outlet conveyor wheel is too large, and adjust the gap of the group outlet conveyor wheel.
3. The peeling setting is not more than 3mm.
4. The feed setting is very large and needs to be adjusted smaller.

3. Wire skin crush injury

1. Adjust the gap between the three-phase five-wire conveyor wheel and the group outlet conveyor wheel.
2. Contact the manufacturer of the computer stripping machine to remove and replace the conveyor wheel.

Fourth, the core is broken

1. Increase the standard value of the cable diameter until it is suitable for the level (the cutter head has just cut the wire skin but the core is not injured as the best position).
2. If the wire skin is too thin, after adjusting to the cable diameter, you find that you cannot peel it, and you can moderately reduce the retract value.

5. The length is different, and the specific line length is greater than or equal to the set line length

1. The gap of the three-phase five-wire conveyor wheel is too large, and sometimes the wire knot cannot be peeled, and the line that cannot be peeled exceeds the set line length, adjust the "three-phase five-wire gap adjustment wheel" to expand the working pressure.
2. If there is dirt in the threading pipe, please check and clean it appropriately.
3. Adjust the working pressure of the three-phase five-wire conveyor wheel.

6. The length is different, and the specific line length is less than or equal to the set line length

1. The size of the transmission line itself is not -.
2. The flip wheel has dirt and needs to be removed. There is wax on the surface of the transmission line, which causes the transfer wheel of the entry and exit line to run off.
3. Remove the line, set the program flow to "00", empty operation, shut down, check whether the rotation of the "in, group outlet wheel" is convenient or stuck.
4. The pay-off frame is stuck, causing the typing line to run off.

7. Some of the wire cores are too long

1. The cable diameter is very small, the knife cuts to the core, and it is taken out when stripping, and the cable diameter value needs to be expanded by 1-2.
2. The feed setting is very small, and the main parameters of the feed are expanded as much as possible.

8. Sometimes the transmission lines are connected together and are not disconnected by the computer stripper

1. Add oil to the wound theme activity location and try again (-generally give oil every 8 hours).
2. Increase the rate and try again.
3. Check whether the specifications and models of the transmission line are within the allowable scope of the specifications and models of this model.
4. Whether the knife head is dull.
<>. The wound is crooked when the thread is broken

1. The cable itself is too bent and needs to be straightened.
2. The cable port is not directly facing the wound management center.